Winter Season-Maintenance - KIRAMI 2000 Guia Del Usuario

E N
•
Position the new pump by passing the cable under the base.
•
Fasten the four screws and fasten the base again, then connect the equipment to the transformer.
•
Reassemble the equipment in the pool by following the instructions in the paragraph INSTALLATION in this manual.
ATTENTION: the transformer is equipped with an auto restoring thermo-protector, that interrupts the electrical input when
the internal temperature gets too high. Once the temperature reaches again an adequate level, the transformer starts again
to work correctly.

Winter season-maintenance.

Product components that, due to their normal use, suffer wear and/or tear must be regularly replaced to ensure good
product performance. The following table shows the perishables and/or consumables used in the product and their
estimated working life.
To guarantee the preservation of the equipment during the winter season, when the equipment is not used for long periods
of time, the equipment must be covered, therefore it must be disassembled from the pool, all of its components must be
dried using a soft cloth or paper towel as to not scratch them, keeping them in their original package in a dry place is
recommended. Taking advantage of this period to visually check the state of the cable and all the other electrical
components is advisable and if substituting them is necessary, follow the instructions described in the paragraph
ELECTRICAL COMPONENTS.
After the winter season the equipment can be installed again as if it were new.
Synptom
The motor does not start.
The Skimmer does not filter, but
water enters into the pool.
The Skimmer returns dirty water to
the pool.
The filter produces little flow.
File name: Shott_SI2000_Multilanguage.docx
O rings and general seals
Rotor
Bearing
Cause
Lack of current in the electric line.
The cartridge has not been correctly
assembled.
The cartridge is worn.
The cartridge is dirty due to use.
The cartridge is dirty due to use.
Tab. 4.
Page 11-of 40
1 year
1 year
1 year
Solution
Check that there is current in the
electric line.
Check their correct position inside the
Skimmer.
Substitute with a new cartridge.
Washing.
Washing.
Rev. 3 of 07/12/2017