Campbell Hausfeld TL053700AV Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
Your grease gun comes from the manufacturer in 3 pieces. Unwrap each
piece from their protective poly bag. Thread the grease hose into the inlet
port of the grease gun and tighten. To prevent grease from seeping between
grease hose and grease gun, use PTFE tape and an adjustable wrench to
ensure a leak-proof connection.
Determine the method you will be using to fill the grease container tube
from the OPERATING INSTRUCTIONS below.
OPERATING INSTRUCTIONS
Fill container tube with grease using one of the 3 methods described below.
Grease Cartridges:
1.
2.
3.
4.
5.
6.
7.
Filler-Pump Method:
1.
2.
3.
4.
5.
6.
Unscrew the grease gun from the
container tube.
Pull the plunger handle back and out
of the container tube as far as it will
go.
Insert the open end of a 14 ounce
grease cartridge into the container
tube and push the cartridge
completely in to the container tube.
Remove the seal from the grease
cartridge.
Thread the grease gun and container tube back together and turn until
tight.
Press the handle release down to activate the plunger handle rod and
push the plunger handle back into the container tube.
Press the air vent valve several times to relieve any air pockets near the
top of the container tube.
Thread the container tube on to the
grease gun and turn until tight.
Pull the plunger handle back and out
of the container tube as far as it will
go.
Connect the filler-pump hose to the
bulk-fill port.
Pump grease in to the container tube
until filled; disconnect the grease gun
from the filler-pump hose.
Press the handle release tab down to
activate the plunger handle rod and
push the plunger handle back into the container tube.
Press the air vent valve several times to relieve any air pockets near the
top of the container tube.
Figure 2
Figure 3
3