Dimplex BOF4056 Manual Del Propietário página 7

Installation
Figure 1
BOF4056
19.5in (495mm) 27.8in. (706mm) 11.0in. (279mm) 16.3in (413mm) 15.6in. (395mm)
BOF4068
19.5in (495mm) 32.6in. (828mm) 11.0in. (279mm) 16.3in (413mm) 20.4in. (517mm)
BOF6056
25.8in. (655mm) 27.8in. (706mm) 11.0in. (279mm) 22.4in (569mm) 15.6in. (395mm)
!
NOTE: If installation in a cus-
tom mantel is desired, a power
cord accessory is available (BOF-
PLUGKIT) to plug the unit directly
into a wall outlet.
2. Allow up to 4 ft. (121.9 cm)
of service cable for connect-
ing a power supply wire to the
cable clamp on fireplace when
installing before finishing wall.
CAUTION: Use two conduc-
tor, non-metallic sheath cable
with ground wire (3 wires total)
for the incoming power supply on
fireplace inserts. Use appropriate
B
A
C
A B
D
C
wire to meet local and national
electrical codes for rated power.
!
NOTE: It is recommended that
all drywall installation and finish-
ing be completed after unit is fully
installed.
3. On the back of the unit remove
the cable clamp, by removing
the screw at the top (Figure 2).
4. Install a 3/8 in. (10 mm) or
1/2 in. (13 mm) cable connec-
tor, not included, suitable for
mounting in a 7/8 in. (22 mm)
hole, to the cable plate and
E
D E
7