Remote Control - Dimplex BOF4056 Manual Del Propietário

Operation
• Press again to return to flame
effect only. This will be indi-
cated by one "beep".
• Press
standby mode. This will be
indicated by one "beep".
D. Flame Intensity Control
Adjusts the intensity of the flame
and smoke effect when the heater
has been activated.
Turning the control knob clock-
wise decreases the intensity of
the flame and smoke effect. Turn-
ing the control counterclockwise
will increase the flame and smoke
effect.
!
NOTE: Give the flame genera-
tor some time to react to changes
you may make on the flame
control knob.
!
NOTE: When the water tank is
empty the unit will turn off after 30
seconds. See instructions under
Maintenance Section for refill-
ing tank. When this procedure is
complete, the main lamps will illu-
minate but it will take 30 seconds
before the flames return.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
to put fire in to
fireplace off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting ten
(10) minutes before switching the
unit back on.
CAUTION: If you need to con-
tinuously reset the heater, unplug
the unit and call Dimplex North
America Limited at 1-888-346-
7539 for technical support. Please
have your model and serial num-
ber ready when calling.

Remote Control

The On/Off Switch must be in the
'ON' ( I ) position in order for the
remote control to operate. There
are 3 buttons on the remote con-
trol. (Figure 8)
!
NOTE: To operate cor-
rectly the remote control must
be pointed towards the remote
control sensor.
The remote control functions are
as follows:
Press once to turn on Flame
effect only. This will be indi-
cated by one beep.
Press once to turn on Full
heat and Flame effect. This
will be indicated by two
13