Tabla de contenido
Publicidad
WHEEL
KIT INSTALLATION
To install your wheel kit, you will need the following
tools:
•
13mm metric box, open end or socket wrench
•
Neddle-nose pliers
Install Wheel Kit as follows:
1.
Place the bottom of the generator cradle on a flat,
even surface. Place temporary blocks under the
cradle to ease assembly.
2.
Slide axle through both axle mounting brackets on
cradle frame.
3.
Slide spacer over each end of axle.
4.
Slide a wheel over the axle.
NOTE: Be sure to install both wheels with the air
pressure valve on the outboard side.
5.
Place the e-ring onto the groove in the axle. You
may add the flat washer if desired.
6.
Place one end of the needle nose pliers on the
bottom of the axle and the other end of the pliers
on top of the e-ring. Seat the e-ring by pressing
the pliers closed.
7.
Repeat step 4 through 6 to secure second wheel.
8.
Secure the vibration mount on the support leg with
lock nut,and 30mm long capscrew.
9.
Fasten the support leg to the bottom of the
generator cradle using two 20 mm capscrews, two
lock washers and two flat washers. Remove
temporary blocks.
10. Position the handle below the muffler bracket on
the frame, as shown. Attach the handle with four
45mm long capscrews and four lock nuts.
11. Recheck all nuts to make sure they are tight and
secure.
Handle
Weld
Nut
Locking
Nut
45mm
Capscrew
Locking
Nut
Support
Leg
Axle
Spacer
Wheel
Washer
E-Ring
Vibration
Mount .
30mm
Capscrew
Flat Washer
Washer
_
20mm
Capscrew
Publicidad
Tabla de contenido
