NOCO Genius Gen Serie Guía De Usuario página 14

TROUBLESHOOTING
WHEN FLASHING LEDS ILLUMINATE
When the battery charger detects an ERROR condition, The Charge
LED(s) will flash, and/or the ERROR LED with illuminate solid. If you
are seeing this ERROR condition, it could be the result of one of the
following situations:
• BATTERY VOLTAGE INCOMPATIBILITY
Check to make sure you have a 12V battery. This battery charger
is for 12V batteries only. If you attempting to charge a battery that
is other than 12V, it could cause this ERROR condition. Charge the
appropriate battery to resolve this ERROR condition.
• LOW VOLTAGE BATTERY
If the battery voltage is below 2.0VDC (12V), it could cause this
ERROR condition. In this situation, the battery charger has
determined that the battery voltage is too low to begin a normal charge
cycle. To increase the battery voltage and allow the battery charger to
begin charging, you will need to jump start the battery.
• ABNORMALITY PROTECTION
This ERROR condition is the result of the battery charger being in the
Bulk mode for more than eighty (80) hours. This ERROR condition is
the result of a bad battery. To resolve this ERROR condition, take the
battery to a local battery store for an evaluation.
• BLOWN FUSE IN BATTERY CONNECTOR HARNESS
Check the fuse in the battery connector harness. If the fuse in the
battery connector harness has blown, it could cause this ERROR
condition. Replace the fuse with a 15A Automotive Blade Fuse to
resolve this ERROR condition.
• CORROSION ON BATTERY TERMINALS
Check the battery connections for battery corrosion. If battery
corrosion is present on the battery connections, it could cause this
ERROR condition. Remove the battery corrosion to resolve this
ERROR condition.
• LOOSE BATTERY CONNECTIONS
Check the battery connections to the battery. If the battery connections
are loose, it could cause this ERROR condition. Tighten the battery
connections to resolve this ERROR condition.
• SULFATED, DAMAGED, OR WEAK BATTERY
If you have checked all other possible ERROR conditions and cannot
clear the ERROR, it is probably the result of a sulfated, damaged, or
weak battery. To properly diagnose a sulfated, damaged, or weak
battery, take the battery to a local battery store for an evaluation.
The battery store will advise if the battery can be charged or needs
replaced.