MO-EL LUCCIOLA Instrucciones De Uso página 7

If the supply line where the heater is connected is protected by fuses, be careful
they are 16 A not quick-acting type.
• The heaters should always be installed only using the mounting brackets provided or
supplied as fittings.
• A minimum air gap of 40 cm should always be allowed between the top of the heater and
a ceiling or roof. The appliance should be 60 cm far from the walls (fig. 1).
• A safety distance of not less than 100 cm should always be left in front of the Lucciola
heaters or too near.
• This unit should be mounted at a minimum of 180 cm above ground level (fig. 1). If
installed in a toilet, the height should be 225 cm in zone 1 and zone 2; in zone 3 the mini-
mum above ground level is 180 cm, according with the rules of each Country.
• The appliance must not be located neither directly below, nor in front of a socket-outlet.
• The heater must be installed so as to prevent that the switches can be touched from
those who are in the shower.
• Ensure that there is no possibility of inflammable material, combustible material or cur-
tains coming into contact with the heater, or lie near the heater.
• If the heater is fastened to a patio umbrella or similar, be sure that neither the sheet nor
other floating parts can inadvertently enter into the range of the emitters.
• If the heater is fastened to a patio umbrella, let it touch the sheet only after 5 minutes
after its switching off.
• The heaters are fitted with safety guards. These are intended only to stop large objects
from hitting the emitters. On no account should the heater be operated with the guard
removed.
• All the heaters are fitted with switch and high temperaure silicone rubber flexible cable
(H05 RN-F) conforming to BS 6500.
• The product is in class I and IP65, wich is the protection rate for the units to be used even
outdoor. For keeping the protection rate of the appliance, the connection of the appliance
with the power supply must be done by means of a minimum IP65 system, as per the
standards HD 384 CENELEC for Europe, or international IEC 60346-7-708 1988.
3. LOCATION
While fastening the appliance to the wall or to the upright, be careful that the
slots (fig. 2-D) of the bracket be at the bottom.
The Lucciola range of heaters is deliberately designed to be very flexible in the choice of
position. There are two basic options:
• Wall mounting bracket (fig. 3). Before drilling the holes for the dowels, be sure that the
wall is solid and that you are far from water tubes or electrical wires. For fixing the appli-
ance at the wall, drill 3 holes with a 5 mm diameter bit and fix the wall bracket (fig. 2-A)
that you find in the box by proper dowels and screws, ensuring that the slots (fig. 2-D) be
at the bottom. Then adjust the angle of the appliance; at last make it firm tightening the
sideward screws (fig. 2-C).
• Mounting on upright (fig. 4) or patio umbrella (fig. 5). The appliance can be fastened to
a upright or to the ribs of a patio umbrella, by the optional upright bracket (code 789 – fig.
2-B). The section of the upright or the ribs can be circular with diameter between 20 and
45 mm, or square with side between 18 and 33 mm. The mounting options are shown in
fig. 8. Before tightening the 2 rear knobs to fasten the bracket, ensure that the slots (fig.
7