Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: T oprevent serious injury, never
I
perform maintenance
orrepairs withunit r unning.
I
Always service and repair a cool unit.
WARNING:
Avoid accidental starting. Stop
I
motor and disconnect extension cord prior to
I
performing any maintenance or repairs.
REMOVING AND REPLACING TINES
Cultivator tines are subject to wear and should be replaced if
any signs of damage are present. Tines should also be
removed and cleaned after each use.
I_
ARNING:
Cultivator tines are sharp. Always
wear leather gloves to protect your hands when
handling tines.
To replace
the cultivator's
tines:
1.
Remove the click pin found at the end of each tine shaft.
NOTE: Each tine assembly is stamped either "A" or "B" (Fig.
9). Note each tine's location on the shaft for easier
reassembly.
I
WARNING:
Do not wash cultivator with a hose.
Avoid getting water on motor and electrical
connections.
I
2.
Carefully remove each tine assembly from the tine shafts.
3.
Wipe each tine shaft clean with a damp cloth and apply a
light coat of oil (i.e. 3-N-One) or silicon-based
lubricant to
each shaft. Do NOT use WD-40.
4.
Rinse each tine assembly with water and thoroughly dry
each it before placing on tine shaft.
5.
Re-insert each click pin to secure the tine assemblies in
place.
Tips for Replacing
Tines
•
Each tine shaft holds one tine assembly stamped "A" and
one tine assembly stamped "B".
•
The bell sides of both tine assemblies (on each shaft)
should face each other (Fig. 9).
•
The hub of each tine assembly (Fig. 9) should face outward
(away from the cultivator's
gearbox).
Click Pin
Gearbox
Hubs
Fig. 9
Bell Side
of Tines
10
Publicidad
Tabla de contenido
