Typical Installation - Little Giant 6 Serie Manual Del Proprietário

INSTALLATION
Physical Installation
8. Connect the pump to an appropriate power supply following the instructions in
tions" on page 7.
9. Test the operation of the pump system by following the instructions in
of this manual. Do not attempt to operate the pump without water; this will damage the seals and
bearings and could result in permanent damage to the pump.
10. Place cover over basin. This cover will help prevent debris from entering the pit and will guard against
accidental injury.

Typical Installation

I
Sump Cover
3/16" Dia. Bleed
Hole in Discharge
Pipe
Power Cord
Taped to Pipe
On Level
6
Discharge Pipe no smaller
than Pump Outlet
Check Valve
Off Level
"Electrical Connec-
"Operation Testing" on page 9
Separate Protected and
Grounded Service Outlet
Wall
4 Ft Minimum
Union or Hose
Footing
Sump Pit 18" Diameter
Minimum x 24" Deep
Typical Poured
Concrete Bottom
Connection