Wall Fixation; Ground Installation; Installation With Lowering Device - Wilo Flumen OPTI-TR 20-1 Instrucciones De Instalación Y Funcionamiento

en-US
6.4.2

Wall fixation

Fig. 5: Wall fixation
6.4.3

Ground installation

Fig. 6: Ground installation
6.4.4

Installation with lowering device

22
Installation and electrical connection
In the case of wall fixation, the mixer is mounted directly on the basin wall. Lay the connec-
tion cable against the basin wall and lead it upwards.
‡
Operating space/installation site is prepared for installation. Defined clearances to fix-
tures and basin walls in accordance with consulting documents.
‡
Mixer is not connected to the power supply.
‡
For installation at heights over 1 m, use scaffolding with a safety harness.
1. Have 2 persons position the mixer against the basin wall and mark the fixation holes.
2. Set the mixer down outside of the working area.
3. Drill fixation holes and insert anchor bolts. NOTICE! Follow the manufacturer's instal-
lation instructions!
4. Once the anchor bolts have hardened in place, have 2 persons place the mixer on the
anchor bolts and fix in place with fixation material.
5. Fix the mixer firmly against the basin wall. NOTICE! Follow the manufacturer's instal-
lation instructions!
6. Lay the connection cable against the basin wall so that it is lightly taut. CAUTION! If
the connection cable leads over the edge of the basin, beware of potential abrasion.
Sharp edges may damage the connection cable. Bevel the basin edge if necessary!
7. Apply corrosion protection (e.g. Sikaflex): Fill the slotted holes on the motor flange up
to the washer.
▶ Mixer is installed. Make the electrical connection.
In the case of ground installation, the mixer is fixed to the floor of the basin using a mount-
ing bracket. CAUTION! If the mixer is ordered for ground installation, the mounting
bracket comes pre-assembled. If the mixer is delivered without a mounting bracket, or-
der the appropriate mounting bracket from customer service! Lay the connection cable
along the basin floor and up the basin wall.
‡
Operating space/installation site is prepared for installation. Defined clearances to fix-
tures and basin walls in accordance with consulting documents.
‡
Mixer is not connected to the power supply.
‡
Mounting bracket mounted on the mixer.
1. Have 2 persons position the mixer on the basin floor and mark the 2 fixation holes.
2. Set the mixer down outside of the working area.
3. Drill fixation holes and insert anchor bolts. NOTICE! Follow the manufacturer's instal-
lation instructions!
4. Once the anchor bolts have hardened in place, have 2 persons position the mixer on the
anchor bolts and fix in place with fixation material.
5. Install the mixer firmly to the basin floor. NOTICE! Follow the manufacturer's installa-
tion instructions!
6. Lay the connection cable against the basin floor and the basin wall so that it is lightly
taut. CAUTION! If the connection cable leads over the edge of the basin, beware of
potential abrasion. Sharp edges may damage the connection cable. Bevel the basin
edge if necessary!
7. Apply corrosion protection (e.g. Sikaflex):
- Sealing joint between mounting bracket and structure.
- Fill holes in the baseplate of the mounting bracket.
- Fill scratches in the mounting bracket.
▶ Mixer is installed. Make the electrical connection.
The mixer is lowered into the basin using a lowering device. The lowering device's guide pipe
leads the mixer safely to the operating point. The resultant reaction forces are transferred
WILO SE 2019-01