Magic Chef MCSCWD27W5 Manual Del Usuario página 8

• The location must be large enough to allow the washer door to be fully opened� The door opens more than
90° , and is not reversible�
• Additional spacing should be considered for ease of installation and servicing�
• Minimum spacing of 1" (25 mm) on all sides of the washer is recommended to reduce noise transfer�
• Additional clearances might be required for wall, door, and floor moldings�
• Spacing for companion appliance should also be considered�
INSTALLATION
CAUTION: Packing materials may be dangerous to children�
Please dispose them properly and DO NOT let children play with
any packing materials�
Before using this washing machine, transport bolts must be
removed from the backside of this machine� Please take the
following steps to remove the bolts:
1� Loosen all bolts and then remove them�
2� Insert the transport hole plugs into the holes�
3� Keep the transport bolts for future use�
Make sure that the small foam triangle is removed with the bottom
foam piece� If not, carefully lay the unit down and remove it�
When you unpack your washing machine, check if there is any
damage or missing pieces� If any items missing, please contact
customer service�
LEVELING THE WASHER
1� When positioning the washing machine, make sure the
legs are screwed in close to the cabinet� If not, turn them
to their original positions by hand or with a wrench and
tighten the nuts with a wrench�
2� After positioning the washing machine, push on all four
corners at the top of washing machine� If the washing
machine has any wobble, or is not stable when being
pressed, adjust the leg to level the machine�
3� To level the unit, loosen the lock nut with a wrench and
turn the leg by hand until it tightly contacts with the floor�
Press the leg with one hand and tighten the locking nut
close to the cabinet with the other hand�
4� Repeat steps 2 and 3 as needed�
5� Use a bubble level to check front to back, side to side, and
corner to opposite corner to ensure the washing machine
is level� Repeat above steps if needed�
8
Figure 3
Figure 4
Figure 5
Figure 6