Craftsman 536.887752 El Manual Del Propietario página 28

TRACTION DRIVE CABLE ADJUSTMENT
1. Runthe engine untilthe fuel tank is 6. Puehthe bottomof the traction
empty and the engine stops.
2. Stand the snow thrower up on the
front end of the auger housing.
3. Loosen the bolts on each side of
the bottom panel (see Figure 45).
Bolt Bottom Panel
Auger
Housing
'\ \ Bolt _.._J
Figure 45
drive cable through the cable ad-
justment bracket until the "Z"
hook can be removed.
7. Remove the "Z" hook from the
cable adjustment bracket. Move
the "Z" hook down to the next ad-
justment hole.
8. Pull the traction drive cable up
through the cable adjustment
bracket.
9. Put the cable boot over the cable
adjustment bracket.
10. To check the adjustment, depress
the drive lever and check the length
of one of the drive springs. In cor-
rect adjustment, the length of the
drive spring is:
minimum 3" (76 mm.)
maximum 3-3/8" (85 mm.)
(see Figure 47).
4. Remove the bottom panel.
5. Slide the cable boot off the cable
adjustment bracket (see
Figure 46).
3-3/8" max. .....
mrriav(ti_nblef J_/_
Cable Boo
Cable Adjustment /_f
Hook
Bracket Figure 46
F-031027L 28