DuPont WFRO60X Serie Instrucciones De Instalación página 11

STEP 8
Install RO System and Drain In Remote Location
INST LL REMOTE DR IN POINT ND IR G P (Remote Location)
You can also run the drain tubing to an existing drain in the house.
sump, etc. are suitable drain points. This type of drain is preferred over the drain connector. Check your
local codes. Longer lengths of tubing (see parts list in manual) may be needed.
lways be sure to provide an air gap between the end of the hose and the drain point. This will prevent
water from backing up into the system. ir gaps are required code in most areas.
TO INST LL REMOTE DR IN POINT, COMPLETE THE FOLLOWING STEPS:
1 R
Remove the 1/4" Red Plastic Tubing
2
Determine if this length is long enough to reach the drain point. If it is, then insert Restrictor
tubing and then insert this end of tubing into drain port on RO Membrane Filter
3
If not, replace the 1/4" Red Plastic Tubing
I
Then insert Restrictor in end of tubing and then insert this end of tubing into drain port on RO
B 2
Membrane Filter . Refer to Step 6 in manual on how to disconnect and connect tubing.
4
Run the tubing to the drain point and secure at the end with a bracket (purchased locally).
Provide a 1-1/2" air gap between the end of the tube and the drain.
5 T
Remove 3/8" White Plastic Tubing
6
Faucet will not have 1/4" or 3/8" tubing attached to the airgap barbs in the RO Faucet Body
remote installation.
WFRO60X
floor drain, laundry tub, standpipe,
P
from the RO Faucet Body by pulling gently.
B 2
R
with an adequate length of tubing to reach the drain point.
P
from RO Faucet Body and discard.
8
I
in end of
.
P
for
10
V4.1