Numbering Of Module(S) Connected To The Control System; Web-Based Access Configuration - Jacuzzi sasha Manual De Instalacion Y Uso

1 2 3 4 5 6 7 8
1
✐
9

NUMBERING OF MODULE(S) CONNECTED TO THE CONTROL SYSTEM

Each sauna and/or hammam modules connected to the control sys-
tem must be identified by a number that must be saved as described
hereafter (if different appliances are connected, it is recommended
to prepare a summarizing diagram of all modules connected, num-
bering them in progressive order as the example in the figure (1S:
first saunna, 1S: first hamman, 2S: second sauna, etc.).
NOTE: before using the switches, clearly note their positions,
so that you are able to return them to these positions at the
end of the procedure.
■ (✐ 9, detail 1) Bring the switch indicated, (located in the elec-
trical box) to the ON position, see also ✐ 7) .
■ ( detail 2) After consulting the table, use the indicated switch-
es (1, 2, etc.) to set the sequence which identifies the number (S)
or (H) assigned to the Sauna or Hammam module.

WEB-BASED ACCESS CONFIGURATION

NOTE: ensure a Web navigation programme ("browser") is avail-
able; we recommend using the latest versions of Mozilla® Firefox®
or Internet Explorer.
■ Check that the control system has been previously connected
to an Ethernet (LAN) or wireless (WLAN/Wi-Fi) network (see ✐ 6)
and that it has been powered (see also Chapter "Checks").
s/h
1 2 3 4 5 6 7 8
OFF
ON
sasha/sasha USA
s/h 1 2 3 4
ON off off off
1s/h
off ON off off
2s/h
ON ON off off
3s/h
off off ON off
4s/h
ON off ON off
5s/h
1s 1h 2s
s h
1 2 3 4 5 6 7 8
OFF
ON
sasha mi
s(h) 1(4) 2(5) 3(6)
ON off off
1s(h)
off ON off
2s(h)
ON ON off
3s(h)
off off ON
4s(h)
ON off ON
5s(h)
3s 2h
Example: for Sasha models, to save the first "sauna" module - or
the first "hammam" module - (respectively "1s" or "1h") flip switch
1 downward (on) while switches 2, 3 and 4 upwards (off ).
As for Sasha mi models, relative saving must be done at the
same time because the "sauna" and "hammam" modules are con-
tained in the same appliance.
In the example at hand, to save the "sauna" module ("1s" ) of the
first appliance, flip switch 1 downwards (on) and 2 and 3 up-
wards (off ); act in the same manner to save the "hammam" mod-
ule ("1h), using switches 4, 5 and 6.
■ (detail 3-4) Power for a few seconds (turn the switch that sup-
plied power to the appliance on and off ).
■ (detail 5) bring the indicated switch, once again, to the OFF
position.
■ Ensure that the computer (or smartphone, tablet, etc.) as-
signed to monitor Sasha is on and connected to the network.
Then open the programme ("browser") to navigate the Web
and type the indicated address in the navigation bar:
27
5"
2
3
4
1 2 3 4 5 6 7 8
5