Programme Activation; Programming; Turning Off Programmes; Lighting (Cromodream® Function) - Jacuzzi sasha Manual De Instalacion Y Uso

See the Sasha user manual for a detailed description of func-
tions.

Programme activation

- Activation is achieved by clicking on the keys present on the display
(this locks the respective keypad until function termination); where
the keypad is used for activation, it is not subsequently possible to
use the remote control system.
Where activation is not possible, Sasha is most probably off or the
parameters used by the computer to connect to the network have
not been configured (refer to the Chapter "Web-based access con-
figuration").
■ Provide power to the appliance and wait until preliminary op-
erations have been completed, which lasts a few minutes (during
this time, the thermometer symbol flashes, both on the display
and on the keypad).
■ When the thermometer symbol stops flashing, it is possible
to immediately activate the selected programme by clicking on
the relative key or by setting a different start and end time (see
Chapter "Programming").
NOTE: in several models, this symbol flashes after
a program has been engaged to signal that the
water softener tank is empty: fill the tank with the
correct amount of fluid (see the user manual).

Programming

■ Setting the start and stop time: the relative fields light up yel-
low (time setting goes up in 15 minute increments).
■ Click on the desired programme: the key will light up yellow
(where the programme has been directly activated, without setting
the start and stop times, the key will light up green).
■ When the activation time is reached, the relative key lights up
green whilst the time countdown initiates.
NOTE:
- in some models the number of hours of operation depends on
whether the keypad is locked (see the user manual, Chapter. "Func-
tions associated with keypad lock").
- once the program has been engaged, the user can still change the
shut-down time as long as the relative keys are yellow.
■ It is possible to move from one programme to the next by
clicking on the symbol which corresponds to the desired pro-
gramme.
■ The vertical bars next to the number values indicate, accurate
approximation of the temperature reached within the hammam
area.
See the user manual for the typical operating temperatures for
each programme.

Turning off programmes

■ Click on the "STOP" key: the key relative to the programme will
turn off.
NOTE: it is possible to switch off the programmes using the "STOP"
key even where they have been activated from the Sasha keypad.
Lighting (Cromodream® function)
Operation is the same as that of the sauna; in any case, refer to the
relative chapter.

Scale removal cycle

The preliminary operations and activation of the scale remov-
al cycle must be initiated from the keypad (the display only
presents progress and/or warning messages).
See the usage manual for all details on the scale removal
cycle.
■ When the number indicated (Sasha: >40; Sasha mi: >20)
lights up, it serves as a reminder that it is now possible to carry
out a scale removal cycle (in Sasha models the number of ham-
man sessions is equal to or greater than 40 but less than 60, while
they are equal to or greater than 20 and less than 30 for Sasha mi).
34