Publicidad
Idiomas disponibles
Idiomas disponibles
First Section - FOR THE USER
WORKING AND USE
The dishwashing machine 050F can wash up to 500 dishes every hour.
The machine protection degree is IP21, therefore it should not be washed with direct high pressure jet water.
The objects to be washed should be correctly arranged for a good washing-up result.
We suggest to descale glasses, from time to time, in order to remove calcareous and/or starchy sediments
by soaking them in suitable solutions suggested by your cleansing agent supplier.
If you need to buy new dishes remember the following: Dishes and cups: preference must be given to
china or non-porous pottery articles, with smooth surface. Glasses: choose a glass suitable to be washed
in dish-washing machines. Surfaces must be smooth and bottoms as flat as possible.
OPERATION BEFORE WORKING
B
EFORE STARTING THE WORKING OPERATION MAKE
:
SURE THAT
-
the cock is open;
-
the
filter and
the overflow
their
housings;
-
the wash arm and the rinse arm are free to
pivot;
-
the rinse aid dispenser containers are
loaded.
CAUTION: Observe the safety notes and
dosage data for the use of chemicals. During
the use of the chemical substance wear
protective clothing, gloves and protective
glasses.
Do
not
products.
T
:
HEN PROCEED
A
-
Open
the door and put into the tank,
possibly over the pump filter, about 54 gr.
of non-lathering detergent in powder.
Every 10 cycles add about 40 gr. of detergent.
If the machine is provided with an automatic
dosing device, control that the detergent is in its
container.
B
-
Place the dishes in the basket minding to
previously remove all solid waste and fat.
Do not overload baskets, dishes must not be
placed one upon the other, water must have the
way to run on each part of the same.
C
-
Turn the machine on by using the wall
switch and push the switch "A" on the control
panel (DIS.1).
The green lamp "G" lights up and the machine
loads automatically (with closed Door).
are in
mix
different
cleaning
N.B.: If the machine is equipped with a water-
softener with automatic regeneration, each 90
seconds of tank filling duration, the machine stops
for about 2 minutes to carry out the regeneration.
Once the loading has been completed, the green
lamp "F" blinks: it indicates that the machine is
ready to start the washing cycle.
Before starting the cycle, check that the lamp "E"
is ON: it indicates that the washing water and the
rinsing water have reached the ideal working
temperature.
D
-
Put the basket into the machine.
Close the door and push the button "B".
The lamp "F" stays ON without blinking and it
indicates that the cycle has begun.
The cycle will start for 2 minutes, including,
besides the washing, a five seconds stop and the
rinsing of 18 seconds with clean water at 85°-
90°C will start.
Once the cycle has ended, the lamp "F" restarts
blinking.
Note:
The
rinse
temperature of the water is 90°C.
Bear in mind that the opening of the door
interrupts the cycle and therefore the machine at
any moment. Pratically, the opening of the tank
works as an emergency device.
E
-
Take the basket away and repeat the
operation "D".
NOTE. STOP CYCLE function: the washing
cycle can be stopped if you push again the cycle
pushbutton "B" (light "F" flashing now) :
to restarting washing cycl push again button "B".
25
ENGLISH
starts
only
when
the
Publicidad
