Regulator - Nostalgia Products Kegorator KRS2100 Serie Manual De Instrucciones

REGULATOR

The Double Regulator works the CO 2 Tank and measures PSI (pounds
per square inch), as well as the volume of the CO 2 gas in the Cylinder. Set
Output Pressure Gauge between 8-12 PSI for a nice, frothy head.
Output
Pressure
Gauge (0-60
PSI) for measuring
PSI of CO 2 outflow
from Tank to Keg
(8-12 PSI
recommended).
Tank
Pressure
Gauge
(0-3000 PSI) for
measuring PSI
of CO 2 in tank.
Pressure Relief Valve
1. Close the Shut Off Valve on the Double Regulator, and
open the CO 2 Tank Valve (#9) completely.
2. Unlock Screw using Allen Wrench (included). Slowly turn the Double Regulator
adjustment screw until the desired pressure is shown on the Output Pressure
Gauge (8-12 PSI). Turning clockwise will increase the output pressure,
and turning counter-clockwise will decrease the output pressure.
3. Once desired pressure is reached, you may re-lock Screw using Allen Wrench.
4. Open the CO 2 Shut Off Valve on the Double Regulator to allow gas flow
from the Double Regulator to the Keg Coupler. You will hear the keg
pressurizing. The output needle will drop momentarily until the pressure
has equalized. Then the needle will return to the point you set it at.
5. The Keg Coupler is designed with a pressure relief valve (PRV). Pull the ring on the
PRV briefly to allow gas to vent. This will permit gas to flow through the Double
Regulator and help obtain a more accurate reading on the Output Pressure Gauge.
6. Re-check the output pressure on the Double Regulator, and if necessary re-adjust using step
#2 until the desired pressure is shown. It is always wise to follow up any adjustment to the
Double Regulator with a brief pull of the PRV ring to ensure an accurate output reading.
Screw adjusts the
output pressure.
CO 2 Shut Off
Valve (shown in
open position)
8