Checking The Provided Options; Turn-On Tests - R&S ETC Compact Manual De Instrucciones

R&S ETC
4.4

Checking the Provided Options

The R&S ETC may be equipped with options. In order to check whether the installed
options correspond to the options indicated on the delivery note, proceed as follows.
1. Press the SETUP key.
2. Tap INSTALLED OPTIONS.
The R&S ETC displays all available options with the appropriate status.
If an option is installed, the installation status differs for permanent or temporary
installed options.
4.5

Turn-On Tests

Perform functional tests only in operating temperature. See data sheet for the
required warm-up time.
The self alignment in network analyzer mode is described in the user manual, chapter
"Basic Instrument Configurations".
Checking the Date of the Last Self Alignment
1. Press the SETUP key.
2. Tap INSTRUMENT SETUP.
3. Select SELF ALIGNMENT DATE.
Getting Started 2116.7884.02 - 04.00
Switching On or Off the Instrument
32