Disposal And Recycling; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL ERGOTOOLS E-PST 800 L Manual De Instrucciones

Sierra de vaivén electrónica
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
Anleitung E-PST 800 L_SPK7:_
GB
When cutting metal, apply a suitable coolant
along the line you wish to cut.
6.7 Sawing out sections (Fig. 15)
Drill a 10 mm hole in the section you wish to saw out.
Insert the saw blade into this hole and start to saw out
the required section.
6.8 Making parallel cuts (Fig. 16)
Mount the parallel stop and adjust as required
(see section 5.3).
Observe the instructions in section 6.6.
Cut as shown in Figure 16.
6.9 Making miter cuts (Fig. 17)
Set the angle on the soleplate (see section 5.4).
Observe the instructions in section 6.6.
Cut as shown in Figure 17.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
16
28.04.2008
16:15 Uhr
Seite 16
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.

Publicidad

Tabla de contenido
loading

Productos relacionados para EINHELL ERGOTOOLS E-PST 800 L

Este manual también es adecuado para:

43.210.91

Tabla de contenido