Rowenta PRO MASTER Serie Guia De Inicio Rapido página 8

PROBLEMS?
Problems Cause
The iron is plug- No power from the outlet.
ged in, but the so-
leplate of the iron
Temperature control set too low.
remains cold.
The automatic electronic auto-off*
is active.
None or too little Steam control set on dry position .
steam is being
Not enough water in the water tank.
emitted.
Anti-Drip is active (§ 9).
Brown streaks Residues in the steam chamber or
come through on the soleplate.
the holes in the
Use of chemical descaling agents.
soleplate and stain
the linen.
Fabric fibers have accumulated in
the holes of the soleplate and are
burning.
Your linen is not rinsed sufficiently
or you have ironed a new garment
before washing it.
Use of starch.
Pure distilled / demineralized or sof-
tened water is being used.
Iron is leaking. Overuse of shot of steam button.
Soleplate temperature too low .
Damages on the iron' soleplate and the steaming function due
to use of the wrong water (see 'what water may be used ?') and
missing maintenance (see 'Anti calc') cannot be accepted as re-
turn under warranty.
* depending on model
Solution
Check that the power plug is properly inserted or try
plugging the iron into a different outlet.
Set the temperature control to a higher temperature.
Move your iron.
Turn the steam control to the required setting area.
Fill the water tank.
Wait for the soleplate to reach the correct temperature.
Use the Anti Calc function then clean your iron.
Do not add any descaling agents to the water in the
water tank. Use the Anti Calc function and clean your
iron.
Clean the soleplate with a non-metallic sponge.
Vacuum the holes of the soleplate from time to time.
Ensure linen is rinsed thoroughly to remove any soap
deposits or chemicals on new garments which may be
absorbed by the iron.
Always spray starch onto the reverse side of the fabric
to be ironed and clean your iron soleplate.
Only use untreated tap water or mix half tap water
with half distilled/demineralised water. Use the Anti
Calc function and clean your iron.
Allow more time between each shot.
Set the temperature control to a higher temperature.
8 8