Sima PERLANATO 200 Manual De Instrucciones página 39

 Now place the rail onto 90º position compared with the front square.
- Slightly loosen the 4 screws fixed to the rail.
- Place a square onto the front square and put it towards the disk.
- Move the sliding cart towards and backwards. Check that the disk moves the square.
- Tighten carefully the 4 screws of the sliding cart without moving the alignment.
WARNING Once the alignment is done, the disk has to be separated from the right table 5 mm. It is necessary
when you put the cutting head at 45º position the disk can´t touch the left table.
16