Maintenance; Light Bulb Replacement - Dimplex VCX1525 El Manual Del Propietario

Operation
2. Install one 12 Volt (A23) bat-
tery in the battery holder.
3. Close the battery cover.

Maintenance

  WARNING: Disconnect power
and heater has cooled before
attempting any maintenance or
cleaning to reduce the risk of
fire, electric shock or damage
to persons.
!
NOTE: The fireplace should
not be operated with an accumu-
lation of dust or dirt on or in the
unit, as this can cause a build up
of heat and eventual damage. For
this reason the heater must be
inspected regularly, depending
upon conditions and at least at
yearly intervals.

Light Bulb Replacement

Light bulbs need to be replaced
when you notice a dark section of
the flame. There are two bulbs,
which generate the flames.
Helpful Hints: It is a good idea
to replace all light bulbs at once if
they are close to the end of their
rated life. Group replacement will
16
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
reduce the number of times you
will need to open the unit to re-
place light bulbs.
Light Bulb Requirements:
Quantity of two 60 Watt chande-
lier or candelabra bulbs with E-12
(small) socket base, 120 Volt. Do
not exceed 60 Watt per bulb
Bulb Replacement Instructions:
CAUTION:
at least 5 minutes for light bulbs
to cool before touching bulbs to
avoid accidental burning of skin.
1. Disconnect power supply to
the fireplace either by unplug-
ging the fireplace or switch off
at the breaker panel.
2. Remove glass assembly. Re-
move the screws securing the
glass assembly on the chas-
sis (Figure 4).
3. Hold on to the glass assembly
with both hands then lift the
whole assembly straight up to
Turn unit off, allow
www.dimplex.com