Glass Cleaning; Fireplace Surface Cleaning - Dimplex VCX1525 El Manual Del Propietario

Maintenance
Figure 12
Glass
assembly
remove (Figure 11).
4. Remove the two screws
securing the light block as
shown in Figure 13, then re-
move the light block.
5. Reach in and turn the burnt
bulb(s) counterclockwise to
remove.
6. Replace with new bulbs.
7. Reassemble light block and
glass assembly in reverse
order.

Glass Cleaning

The front glass is cleaned in the
factory during the assembly oper-
ation. During shipment, installa-
tion, handling, etc., the front glass
may collect dust particles, these
can be removed by dusting lightly
with a clean dry cloth.
To remove fingerprints or other
marks, the glass can be cleaned
Lift to
remove
Figure 13
with a damp cloth. The glass
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching,
do not use abrasive cleaners or
spray liquids on the glass surface.

Fireplace Surface Cleaning

To remove fingerprints or other
marks, the exterior finish can be
cleaned with a damp cloth with
a mild detergent. The surface
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching,
do not use abrasive cleaners or
spray liquids on any surface.
Servicing
Except for light bulb replacement
and cleaning described above, an
authorized service representative
should perform any other servicing.
Light
Block
17