Water Connections - Buderus SM80/5 Instrucciones De Mantenimiento Y De Instalación

▶ Position the DHW tank on a level floor with adequate load-bearing
capacity.
Fig. 10 Positioning the tank
▶ Maintain minimum wall clearances.
▶ Using the adjustable foot, align the DHW cylinder vertically.
SM80/5, SM100/5 – 6 720 800 156 (2017/07)
▶ Remove the caps from the connections.
A
B
Fig. 11 Remove caps
▶ Use Teflon tape or Teflon cord to seal the connections. Do not use
6 720 647 567-07.1ITL
hemp to seal the connections.
5.2

Water connections

WARNING: Risk of fire from soldering and brazing!
▶ Take appropriate protective measures when
soldering and welding as the insulation is flammable,
for example, cover the insulation.
▶ Check tank jacket for damage after completing work.
DANGER: Risk of injury from contaminated water!
Work carried out without due care for cleanliness
contaminates the drinking water.
▶ Install in accordance with national standards and
guidelines.
NOTICE: Water damage
▶ Connect the drain to the bottom tank connection
prior to filling the tank.
▶ Seal off all unused tank connections.
NOTICE: Risk of corrosion from damage to the enamel
coating!
▶ Attach connections to the DHW tank only "hand-
tight".
5
Installation
6 720 800 155-22.1ITL
11