Interface Installation - Auto Meter IR-1 Manual De Instrucciones

INTERFACE INSTALLATION

Note: This interface will only work in an
XTC-160 with version 1.4 or later firmware.
3. Carefully pull the interface ribbon cable through the door opening as
shown in the illustration above, but do not disconnect the cable from
the PC board located just behind the front panel.
4. Align the ribbon cable parallel to the interface as shown below.
The interface ribbon wraps in front as shown.
Do not twist or fold the ribbon cable.
5. Carefully attach the ribbon connector to the connector located on the
interface circuit board. Use care and do not force.
6. Install the interface making sure the ribbon is not crimped at the door
edge. Insert the top tab under the panel before tightening
vthe thumbscrew.
7. On the XTC-160. Go to the "Set Up"
menu and set the select printer
setting to PR-16
4
1. Shut off tester, disconnect
any load clamps from the
battery and unplug the unit
from any AC source before
installing the IR-1 Interface.
2. Loosen the thumbscrew at
the bottom of the interface
cover plate and remove entire
cover. Save cover if you think
you might want to use your
tester without an interface.
Do not operate without the
IR-1 Interface or cover plate
installed.
INTERFACER INSTALLATION
Récepteur Infrarouge
Cette fenêtre doit rester claire
d'obstructions si un Auto Meter part
tenue testeur est utilisé pour envoyer
un signal infrarouge.
NOTE: Si le récepteur infrarouge sur l'interface est exposé à la lumière
directe du soleil, l'interface peut ne pas fonctionner correctement.
Activer l'interface afin que le récepteur infrarouge n'est pas exposé
à la lumière directe du soleil et réduire la distance de part tenue
testeurs..
21