GE 20 Manual Del Propietario E Instalación página 4

Congelador inferior
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

About
the
controls with temperature settings.
(on some models)
[]
[]
TEMPERATURE SET
WARMER
_
_WARMER
COLDER
COLDER
0 o F Recommended
37_F Recommended
[]
[]
[]
Nold
3 seconds
to _eset
NoEd 3 seconds
(on some models)
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
The temperature
controls are preset in the foctorbl at 37°F for the refrigerator
compartment
and O°F for the freezer compartment.
Allow 24 hours for the temperature
to stabilize to the preset recommended
settings.
The temperature
controls con displab_ both the SET temperature
as well as the actual
temperature
in the refrigerator
and freezer. The actual temperature
mabl varbl slightlbl
from the `SETtemperature
based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments,
but does not shut off electrical power to the refrigerator.
4
Changing
the Temperature
For Controls-on-the-Door
Models:
To change the temperature, press and release the
WARMERor COLDERpad, The ACTUALTEMPlight
will come on and the display will show the actual
temperature. To change the temperature, tap either
the WARMER or COLDERpad until the desired
temperature is displayed.
For Controls Inside the Refrigerator:
Opening the door displays the actual temperature.
To change the temperature, press either the
WARMERor COLDERtouch pads until the
desired temperature is displayed.
Once the desired temperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after 5 seconds.
Several adjustments may be required.
Eachtime you adjust controls, allow 24 hours for the
refrigerator to reach the temperature you have set.
To turn the cooling sgstem off,,tap the WARMERpad
for either the refrigerator or the freezer until the
displag shows OFF.To turn the unit back on, press
the COLDERpad for either the refrigerator or freezer
Then press the COLDERpad again and it will go to
the preset points of O°Ffor the freezer and 37°Ffor
the refrigerator Setting either or both controls to
OFFstops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power
to the refrigerator

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

2223

Tabla de contenido