Tools Required; Inst-5000; Dash Disassembly; Kit Assembly - Metra INST-5000 Instrucciones De Instalación

Kit Assembly

DIN radio provision

1. Remove the metal DIN cage
from your aftermarket radio.
2. Slide the DIN cage into the
housing and secure by bending
the metal locking tabs down.
(Figure A)
3. Slide the aftermarket radio into
the cage until secure.
4. Locate the factory wiring
harness in the dash. Metra
recommends using the proper
mating adapter from Metra
or AXXESS. Re-connect the
negative battery terminal
and test the radio for
proper operation.
(Figure A)
5. Mount the rear support bracket
to the back of the radio. Snap
the radio/kit assembly into the
sub-dash (be sure the rear
support bracket engages the
support shelf in the dash).
(Figure B)
6. Reassemble dash in reverse
order of disassembly.
Note: If an equalizer will be
included, slide the equalizer into
the back of the radio housing
and secure. If an equalizer will
NOT be included, snap
the equalizer dummy plate into
the opening.
(Figure B)
3.2
Section 4
Ford
1997-1998
99-5800
KIT FEATURES
• DIN radio provision with pocket
KIT COMPONENTS
• A) Radio housing
A

TOOLS REQUIRED

• Socket set • Cutting tool
• Dremel tool • 86-5618 or
AW-FDRT Removal keys

INST-5000

WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness:
• 70-1770 - Ford/Lincoln/Mercury harness
for select 1985-2004
• 70-5603 - Low-level amplifier integration
harness for select Ford vehicles
Antenna Adapter:
• Not required
Applications
Ford
Expedition ...............................................1997-1998
F-150 .....................................................1997-1998
F-250 .............................................................. 1998
Table of Contents

Dash Disassembly

– All vehicles ...................................................... 4.1
– Rear support removal ...................................... 4.1
Kit Assembly
– Kit preparation ................................................. 4.1
– DIN radio provision with pocket ....................... 4.2
4.0