Connecting To Electricity Source - Sima STAR 20 Manual De Instrucciones

Do not change any electrical configuration in the machine as this may result in irreparable damage
VERY IMPORTANT, make sure earth is connected before connected

7.2 CONNECTING TO ELECTRICITY SOURCE.

The machine has a display so that the user can see the voltaje supplied to the machine before the voltaje
reached the electrical components and causes any damage.
To connect the machine do the following
1. Open the door and connect the socket to the electrical box socket .This way the electricity will not reach
the motor and you can see the voltage coming into the machine.
WARNING: the transformer has a tolerance of
requirement. If these limits are passed then you will break the transformer
2. Turn the black switch to chose the bending direction and the green light will shine.
3. Step on the pedal to check which way the plate is turning. MAKE SURE THERE ARE NO MANDRELS OR
ACCESSORIES ON TOP OF THE MACHINE.
When connecting the machine, make sure the machine is turning in the way the sticker indicates, this
will avoid accidents with the accessories on the bending plate.
If it doesn´t turn the right way please change the phases.
Machine 400V = 360V min / Max 440V max
Machine 230V = 207V min / Max 253V max
±10%
over and below the specified tension
11
ENGLISH