Important Safety Instructions - Kenmore 362 7262 Manual De Uso Y Cuidado

IMPORTANT SAFETY
INSTRUCTIONS
• installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1, latest
edition. In Canada, installation must conform
with the current Natural Gas Installation Code,
CANtCGA-B149.1 or the current Propane
Installation Code, CAN/CGA-B149,2 and
with local codes where applicable.
This range has been design-certified by CSA International
according to ANSi Z21.1, latest edition and Canadian Gas
Association according to CAN/CGA-1 ..1 latest edition.. As
with any appliance using gas and generating heat, there
are certain safety precautions you should followHYou will
find these precautions in the Important Safety Instructions
section in the front of this guide, Read them carefully.
, Have your range installed by a qualified installer.
• Your range must be electrically grounded in
accordance with local codes or, in the absence of local
codes, in accordance with the National Electrical Code
(ANSI/NFPA 70, latest edition)_ In Canada, electrical
grounding must be in accordance with the current
CSA-022.1 Canadian Electrical Code Part 1 and/or
local codes. See Electrical Connections in this section°
o Before installing your range on linoleum or any other
synthetic floor covering, make sure the floor' covering
can withstand 180°F (82°0) without shrinking, warping
or discoloring Do not install the range over carpeting
unless a sheet of I/4" (6 ram) thick plywood or similar
insulator is placed between the range and carpeting,
* Make sure the wall coverings around the range
can withstand heat generated by the range up to
200°F (93°C).
° Avoid placing cabinets above the range. To reduce the
hazard caused by reaching into the cabinets over the
open flames of operating burners, install a ventilation
hood over' the range that projects forward at least 5"
(12,7 cm) beyond the front of the cabinets.
= The ventilating hood must be constructed of sheet
metal not less than 0.0122" (.31 ram) thick Install
above the cooking top with a clearance of not less than
W' (6 ram) between the hood and the underside of the
metal cabinet or combustible material The hood must
be at least as wide as the appliance and centered over
the appliance. Clearance between the cooking surface
and the ventilation hood surface MUST NEVER BE
LESS THAN 24" (61 cm).
EXCEPTION: Installation of a listed microwave oven or
cooking appliance over the cooktop shall conform to
the installation instructions packed with that appliance.
o If cabinets are placed above the range, allow a
minimum clearance of 30" (76°2 cm) between
the cooking surface and the bottom of unprotected
cabinets.
If a 30" (76°2 crn) clearance between cooking surface
and overhead metal cabinets or combustible material
cannot be maintained, protect the underside of the
cabinets above the cooktop with not less than V4"
(6 mm) insulating millboard covered with sheet metal
not less than 0.0122" (,31 ram) thick..
Clearance between the cooking surface and protected
cabinets MUST NEVER BE LESS THAN 24" (6t cm),
The vertical distance from the plane of the cooking
surface to the bottom of adjacent overhead cabinets
extending closer than 1" (2.5 cm) to the plane of the
range sides must not be less than 18" (45.7 cm)°
(See the Dimensions and Clearances illustration in
this section.)
CAUTION: Items ofinterest to children
should not be stored in cabinets above a range or on
the backsplash of a rangeichildren climbing on the
range to reach items could be seriously injured.
38