Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
TO AVOID SERIOUS iNJURY, BEFORE PERFORMING
ANY SER-
ViCE OR ADJUSTMENTS:
1.
Depress
clutch/brake
pedal fully and set parking
brake.
2.
Place
motion
control
lever
in neutral
position.
3.
Place
attachment
clutch
in "DISENGAGED"
position.
4.
Turn ignition
key to "STOP"
and remove
key.
5.
Make sure the blades
and all moving
parts have completely
stopped.
6.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come in contact
with plug.
TO REMOVE MOWER
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Lower attachment
lift lever to its lowest
position.
3. Roll belt off engine pulley (M).
4. Remove retainer spring (K), slide collar
(L) off and push housing guide (P) out
of bracket.
5. Remove clutch cable spring (Q) from
idler arm (R).
6. Disconnect
front link (E) from mower
- remove retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis pin (B) and rear lift link (C)
from rear mower bracket (D) - remove
retainer springs and washers.
8. Go to other side of mower and discon-
nect the suspension arm and rear lift link.
Al_ CAUTION:
After rear lift links are
disconnected,
the attachment
lift lever will
be spring loaded. Have a tight grip on lift
lever when changing position of the lever.
9. Slide mower out from under right side
of tractor.
IMPORTANT:
If an attachment
other than
the mower is to be mounted on the tractor,
remove the front link (E) and rear lift liks
(C) from tractor and hook the clutch spring
(Q) into the cable guide on front edge of
lower dash.
TO iNSTALL
MOWER
Be sure tractor is on level surface and
engage parking brake,
1. Lower attachment
lift lever to it's lowest
position.
A CAUTION:
Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before slid-
ing mower under tractor.
23
03042rex
Publicidad
