Publicidad
Idiomas disponibles
Idiomas disponibles
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal.
The front wheel toe-in and camber are
not adjustable.
If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE
WHEEL
FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining
ring and
washers
to allow wheel removal
(rear
wheels have a square key - Do not lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle. Insert
square key.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant
also prevents tire dry rot and corrosion.
Washers
Retaining
Ring
Axle Cover
I
\Square
Key (Rear
Wheel Only)
TO START ENGINE WITH A WEAK BAT-
TERY
_,WARNING:
Lead-acid batteries
generate explosive gases.
Keep sparks,
flame and smoking materials away from
batteries.
Always wear eye protection
when around batteries.
If your battery is too weak to start the en-
gine, it should be recharged.
(See "BAT-
TERY" in the MAINTENANCE
section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES
-
1. Connect one end of the RED cable
to the POSITIVE
(+) terminal of each
battery(A-B),
taking care not to short
against tractor chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of
fully charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground,
away from fuel tank and battery.
TO REMOVE
CABLES,
REVERSE
ORDER
-
1.
BLACK
cable first from chassis
and
then from the fully charged
battery.
2.
RED cable
last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BATTERY
_IbWARNING:
Do not short battery
terminals
by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting
battery,
remove metal bracelets,
wristwatch bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position.
2. Disconnect
BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3.
Install new battery with terminals in
same position as old battery.
4.
First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5. Connect BLACK grounding
cable
to negative (-) terminal with remain-
ing hex bolt and keps nut. Tighten
securely.
27
Publicidad
