Door Reversal - Amana Distinctions Instrucciones Para La Instalación

side by adjusting left and right roller adjustment
screw. Turn stabilizing leg (some models)
clockwise until firmly against floor.
• Turn stabilizing leg clockwise until firmly against
floor.
Roller adjustment
screw
4. Replace toe grille and bottom hinge cover. See
markings on inside or bottom of grille to insure
proper placement.
• Snap top portion into place first. Press down on
lower part of grille until bottom portion snaps into
place.
5. Review Installation Checklist in Owner's Manual with
consumer.

Door Reversal

!
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
Tools Required
Putty knife (blade covered with masking tape)
9 / " hex nut driver (some models)
32
5 / " hex nut driver (some models)
16
3 / " hex nut driver
8
Phillips screwdriver
Blade screwdriver
Some installations require door reversal to achieve full
door swing. To reverse door swing perform the following
steps:
1. Remove and reverse refrigerator and freezer
handles performing the following steps:
IMPORTANT: For plug removal requiring use of flat
blade screwdriver or putty knife, blade of tool must be
covered with masking tape to avoid damage to
refrigerator finish. For plugs using a screwdriver- or
nut driver- style head, use appropriate tool to avoid
damage to plugs.
• Remove end caps from top(some models) and
bottom of refrigerator handle with flat screwdriver
blade wrapped in masking tape. Remove two
screws from top of handle and screw from base of
handle.
Stabilizing leg
WARNING
• Models with automatically reversing log.
Remove end cap from top of freezer handle using
a screwdriver with the blade covered with masking
tape (see illustration below). Remove one top and
two bottom mounting screws.
• Handles with removable logo on handle.
Remove end caps from handles using a
screwdriver with the blade covered in masking
tape. Remove handle screws to remove freezer
handle. Remove freezer handle cover by lifting
end. Bend tabs behind nameplate up and remove
nameplate. Rotate nameplate and cover.
2. Remove top hinge cover. Top hinge cover snaps off.
Remove top hinge and shim using hex nut driver.
3. Lift freezer door off center hinge.
4. Lift door closure off center hinge pin. Remove center
9
hinge pin with / " hex nut driver.
32
5. Remove refrigerator door by lifting off bottom hinge.
6. Remove center hinge bracket and shim using
Phillips screwdriver.
4
Handle
screws
or
End
cap
Handle with
removeable logo
End
caps
Mounting
screws
End
cap