Double Din Radio Provision - Metra 99-7426 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR PART 99-7426

Double DIN radio provision

1. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
2. Cut and remove the center bar
from the radio housing. (Figure A)
3. Snap the double DIN brackets
to the inside edge of the radio
housing. (Figure B)
4. Slide the double DIN radio
into the bracket/radio housing
assembly and secure the radio to
the assembly using the screws
supplied with the radio. (Figure C)
5. Snap the double DIN trim plate
onto the front of the radio/housing.
(Figure C)
6. Reassemble dash in reverse order
of disassembly.
METRA. The World's best kits.
(Figure A) (Figure B)
(Figure C)
1-800-221-0932
™
metraonline.com
© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians