Kit Assembly - Metra 95-7313 Instrucciones De Instalación

ISO DDIN radio provision
1. Attach the radio brackets to the radio housing, aligning
the holes in the radio housing to the clips on the radio
brackets.. (Figure A)
2. Slide the radio in the completed assembly, and then
secure using the screws supplied with the radio.
(Figure B)
3. Locate the factory wiring harness and antenna
connector in the dash. Metra recommends using
the proper mating adapter from Metra or AXXESS.
Re-connect the negative battery terminal and test the
radio for proper operation.
4. Reassemble the dash in reverse order of disassembly.
Note: For the 2003-2008 Hyundai Tiburon
applications, cut and remove the bottom mounting
tabs on the completed assembly. (Figure C)
METRA. The World's best kits.
Installation instructions for part 95-7313

Kit Assembly

(Figure A)
(Figure B)
CUT
(Figure C)
™
CUT
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER