Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DDIN radio provision
1. Using a utility knife, carefully cut
the center bar out of the ISO DDIN
trim panel. (Figure A)
2. Attach the ISO DDIN brackets onto
the ISO DDIN trim plate, aligning
the holes in the trim plate to the
clips on the bracket. (Figure B)
3.
Slide the radio into the trim plate/
bracket assembly, and then secure the
it to the assembly using the screws
supplied with the radio. (Figure C)
4. Using the hardware that came with
the radio, secure the rear support
to the back of the radio. (Figure D)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Re-connect
the negative battery terminal and test
the radio for proper operation.
6. Snap the completed assembly into
the radio cavity until it clicks in.
METRA. The World's best kits.
Installation instructions for part 99-7505
Kit Assembly
(Figure A)
(Figure C)
Note: Once the radio clicks in, it may not be able to be removed
without dashboard disassembly. Ensure all connections are
completed before doing so.
™
(Figure B)
Rear View
DOUBLE DIN Head
(Figure D)
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER
Publicidad
