Iso Din Radio Provision With Pocket - Metra 99-8204 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR PART 99-8204

ISO DIN radio provision with pocket

1. Align the holes in the ISO brackets mount
the brackets to the radio with the screws
supplied with the radio.
2. Slide the radio/bracket assembly into the
radio opening until the side clips engage and
snap the trim plate over the radio. (Figure A)
Note: To remove the mounted radio, unclip
and remove the ISO trim plate. Using a small
flat-blade screwdriver, disengage the side
clips securing the ISO brackets to the radio
housing. (Figure B)
3. Re-connect the battery terminal and test the
radio for proper operation.
4. Snap the factory radio trim bezel
over the kit by engaging the (4) bracket tabs
("A") and (3) housing bosses ("B") to the
back of the bezel.
5. Slide the assembly into the sub-dash and
mount with (4) 10mm bolts previously
removed in Step 1.
6. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect
METRA. The World's best kits.
the negative battery terminal and test the
radio for proper operation.
7. Reassemble dash in reverse order
of disassembly. (Figure C)
(Figure A)
(Figure B)
™ 1-800-221-0932
"B"
(Figure C)
metraonline.com
© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION
"A"
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians