Auto-Cycle Timer Datalogging - RS Pro RS-1151 Manual De Instrucciones

8-4 Auto-Cycle Timer Datalogging

The auto cycle timer means the start-time and the record time is captured
on each occasion.
1. Perform setting the Real-Time. (Refer to 8-1)
2. Press and hold down TIME key then press
the "
3. Press ▲ key 3 times to select this mode, the "
4. Press ↵ key to enter the ON/OFF selecting mode, the "
displayed.
5. Press ▲ key to select "
6. If select "
7. If select "
-
"►
8. Using ► key to position the cursor on the time element to adjust.
Using ▲ key to setting the time element value.
9. Press ↵ key to enter the Record-Time setting mode, the "►
mark is displayed.
10. Repeat step 8 above to complete the record-time setting.
11. Press ↵ key to enter the Interval-Time setting mode, the "
mark is displayed.
12. Using ► key to position the cursor on the minute or second element to adjust.
13. Using ▲ key to setting the desired interval time from 1 second to 59
minutes 59 seconds.
14. Press ↵ key to complete the action and to enter the auto-cycle timer
datalogging mode, the "
15. When the Start-Time is reached, the "
mark is displayed. When the "M" mark appears once it means one set of
data has been memorized.
16. If no SD CARD is in the meter, the "
17. If memory is full, the "
4GB or 99 blocks.
18. Press LOG key for 3 seconds to exit.
09/15/17 Version No. 00
" mark is displayed.
" then press ↵ key to exit.
" then press ↵ key to enter the Start-Time setting mode, the
" mark is displayed.
d-h
" or " ".
" mark is a flashing display.
" mark stops flashing and the "A"
" mark is displayed for 2 seconds.
" mark is displayed. The maximum capacity is
Datalogger Sound Level Meter / EN
key to turn on the meter, until
" mark is displayed.
" mark is
- "
d-h
: "
m:s
13