Making The Electrical Connections - HAMPTON BAY Windward II Manual Del Propietário

Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
Step 1 Connect the fan supply (black) wire to
the black household supply wire as shown in
Figure 13.
Step 2 Connect the neutral fan (white) wire to
the white neutral household wire.
Step 3 Connect the two green fan ground wires,
located on the downrod and mounting bracket,
to the household ground wire. When using
Close-to-Ceiling mounting, there is only one
green ground wire from the ceiling mounting
bracket since the ball/downrod assembly not
used.
8.
Step 4 After connecting the wires, spread them
apart so that the green and white wires are on
one side of the outlet box and the black wire is
on the other side.
Step 5 Turn the wire connecting nuts upward
and push the wiring into the outlet box.
TO REDUCE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT USE A WALL MOUNTED SOLID
STATE SPEED CONTROL WITH THIS FAN. IT
WILL PERMANENTLY DAMAGE THE ELECTRONIC
CIRCUITRY.
EACH WIRE NUT (WIRE CONNECTOR) SUP-
PLIED WITH THIS FAN IS DESIGNED TO ACCEPT
UP TO ONE 12 GAUGE HOUSE WIRE AND TWO
WIRES FROM THE FAN. IF YOU HAVE LARGER
THAN 12 GAUGE HOUSE WIRING OR MORE
THAN ONE HOUSE WIRE TO CONNECT TO THE
FAN WIRING, CONSULT AN ELECTRICIAN FOR
THE PROPER SIZE WIRE NUTS TO USE.
SUPPLY CIRCUIT
Ground
Conductor
Green Ground Lead
Ground to Downrod
Fan Motor
Housing
Blue
White
Black White
Light Kit Assembly
Diagram indicates light kit wiring
Figure 13