Transmitter Operation; Operating Your Remote Control - HAMPTON BAY Windward II Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION - This device complies with part 15
of the FCC rules. Changes or modifications not
expressly approved by the manufacturer could
void your authority to operate this equipment.

Transmitter Operation

NOTE:
Be
sure
to
install
1.5-volt batteries (included).
Fan - Pressing this button steps through
the various fan speeds "High", "Med.", "Low"
and "Off". The fan speed is displayed on
the LCD screen.
Light - Momentarily pressing this button will
turn the light on and off.
For/Rev - Reverses the fan's direction of
rotation.
Timer - Automatically turns the fan/light off
after a pre-selected amount of time. Press the
Timer button followed by the Up and Down
buttons to adjust the time delay before the fan/
light turns off.
Light Delay - Pressing this button activates the
light delay function. The light will automati-
cally shut off after 3 minutes.

12. Operating Your Remote Control

Fan Auto and Temp Set (Up and Down)
- Pressing the Fan Auto button places the fan in
automatic control mode. In this mode the fan
speed is automatically set on "High", "Med.",
or "Low" speed depending upon the room tem-
perature and the user selected temperature set
point. Press the Temp Set Up and Down but-
tons to select the desired room temperature. If
4
fresh
the room temperature is less than the set point
then the fan turns off, if the room temperature
is within 3 degree F over/or equal to the set
point then the fan will be on "Low" speed. As
the room temperature increases the fan will au-
tomatically switch to "Med" and then "High"
speed. For every 4 degree F over the set tem-
perature, the fan will switch to the next higher
speed.
Wall Mount - Your remote control model
comes with a holder included for the transmitter
which can be mounted on a convenient location
on a wall. The holder will help prevent your
transmitter from being misplaced.
The remote control monitors the air temperature
to automatically control the fan speed. Ideally
locate control on an interior wall where it will
accurately read the air temperature away from
direct sun or other heat sources.
SET
SUMMER
POINT
72˚F
75˚F
OFF
71˚F
74˚F
LOW
72-75˚F 75-78˚F
MED
76-79˚F 79-82˚F
HI
80˚F+
83˚F+
WINTER
78˚F
80˚F
77˚F
79˚F
78-81˚F 80-83˚F
82-85˚F 84-87˚F
86˚F+
88˚F+

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido