Leggett & Platt Simplicity 3.0 Manual De Instrucciones página 7

SteP 5
Remove the shipping carton and plastic packaging from the adjustable base frame.
Remove protective film from Micro-Hook™ strips, if applicable. Note: S-cape
base includes a 4-port charging hub at head end of base (FIGURE 2).
FIGURE 2
4-PORT CHARGING HUB
(S-cape + 2.0 base only)
®
(located on each side of
base, for charging low-
voltage devices only; hub is
free-standing on Split queen
bases)
SteP 6
Plug electrical power cord into a working, grounded electrical outlet.
Note: an electrical surge protection device is recommended (not included).
SteP 7
Install batteries in remote control (2-AAA size, included) (FIGURE 3).
Briefly activate all functions of the base with the remote control to verify
all features are in working order. If base does not operate, refer to the
Troubleshooting section of this manual.
FIGURE 3
DISENGAGE LATCH ON
BATTERY COMPARTMENT
DOOR AND LIFT UP TO
REMOvE. INSERT TABS IN
TAB SLOTS AND SNAP LATCH
IN TO REPLACE.
DOOR
LATCH
SteP 8
Return base to the level position.
iNStallatioN
BATTERY
COMPARTMENT
DOOR
S-cape 2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®
+ 2.0
®
7