Remote Control Function - Leggett & Platt Simplicity 3.0 Manual De Instrucciones

flat BUttoN
Press and hold to lower the base to the
flat position. This button will also turn
off the massage motors and underbed
UNderBed liGHt BUttoN
Press to turn on/off underbed light
Head UP/doWN BUttoNS
Press and hold to raise or lower the
head section.
SNore BUttoN
Press and hold to adjust the head
section of the base to a 7° angle. The
section will return to the flat position
after 15 minutes.
mem 1 / mem 2 BUttoNS
Press and hold to adjust the base to the
programmed position.
Head maSSaGe UP/doWN BUttoNS
Press and release to increase/decrease
head massage intensity. Massage has
3 levels: Low, medium and high. Press
the down button when massage in set
to low intensity to turn massage off.
Massage will automatically shut off after
REMOTE CONTROL REqUIRES THREE (2) AAA SIzE BATTERIES. TO CONSERvE BATTERY LIFE, THE
TRANSMITTER TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON IS PRESSED FOR MORE THAN 50 SECONDS.
PRESS & HOLD TO ONE TOUCH
To change remote control functions from "press and hold" to "one touch" ("one touch" = press and release), simultaneously press
the FLAT and HEAD UP buttons for 3 seconds. The massage motors will chirp once confirming the change. Your base is now set to
"one touch."
When in "one touch" (press and release) mode:
• Mem 1, Mem 2, z Grav and Snore buttons
Press and release (one touch) button. Base will adjust to the programmed position. Press any other button to stop the base during movement.
• Flat button
Press and release (one touch) button. Base will shut off massage motor, if active, and adjust base to level position. Press any other
button to stop the base during movement.
To revert back to factory settings, simultaneously press and hold the FLAT button and the HEAD DOWN button for 3 seconds. The
massage motors will chirp once confirming the change. Your base is now set to factory settings. Note: Mem 1, Mem 2, Z Grav and
Snore positions will revert to factory preprogrammed positions.

remote coNtrol fUNctioN

light.
feature.
30 minutes.
S-cape
lock BUttoN
To lock / unlock the remote control
buttons, press and hold lock button for
3 seconds. Backlight will flash 3 times.
foot UP/doWN BUttoNS
Press and hold to raise or lower the foot
section.
Set BUttoN
To program a position, adjust base to
desired position and/or function, then press
and hold the set button AND Mem 1, Mem
2, Snore, or Z Grav. The massage motors
will "chirp" once to confirm success.
zero Gravity BUttoN
Press and hold to adjust the base to the
preprogrammed reclined position for
optimum weight distribution allowing
total comfort and relaxation.
foot maSSaGe UP/doWN BUttoNS
Press and release to increase/decrease
foot massage intensity. Massage has 3
levels: Low, medium and high. Press
the down button when massage in set
to low intensity to turn massage off.
Massage will automatically shut off after
30 minutes.
Wave iNteNSity BUttoN
Press and release to turn on wave feature.
Press wave button again to turn off wave
feature and return massage to non-wave
massage. After wave is activated, press
and hold the button for 3 seconds to cycle
through the wave speeds. To adjust wave
intensity, press head/foot (+) or (-) buttons.
Note
2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®
9