Amann Girrbach Ceramill map 400 Modo De Empleo página 39

I N S T A L L A T I O N
▷ Check the scan result and re-scan, if required.
E N
Fig. 10
▷ Follow the software instructions.
▷ Remove the upper jaw.
▷ Using the required spacer plate (0, 1, 2 or 1+2), position the lower jaw within the measuring range in
the scanner (please refer to section 6.2).
▷ Perform a 2D scan.
▷ Select the number of spacer plates.
▷ Under Scan type, select
Complete Jaw
.
▷ Start the 3D scan with the
Next
button.
▷ Check the scan result and re-scan, if required.
▷ Follow the software instructions.
▷ Remove the lower jaw together with the model set-up (see figure 3 on page 31).
▷ Position both models in the fixator.
39