Avanti ZeroWater Manual Del Propieratio página 7

ZeroWater
®
Use and Care Instructions
Please read before first use.
INSTRUCTIONS BEFORE INSTALLING CARTRIDGE
AND FIRST USE
1. Clean all plastic components and filter cartridges by washing and rinsing
thoroughly with warm water only. Rinse the Filter Bottle thoroughly when
washing with soap.
2. Note: the Filter Bottle components, filter cartridges and TDS meter are not
dishwasher safe.
3. Discard all plastic bags. This may be a suffocation hazard to young children.
A
Filter Bottle
ASSEMBLY
1. Take the lower chamber and place the lower chamber
divider rim firmly on the top. The rippled part of the white
rim should be overlapping the lower chamber. If assembled
upside down, there will be leakage. Be sure it fits tightly
on the lower chamber (see ZeroWater
components
on page 4).
2. Align the nut (included) into the recessed area at the inner
bottom of the lower chamber and screw the float valve
tightly through the hole on bottom of lower chamber (inset
A).
Do not prop the Filter Bottle on the float valve once
assembled, as it is fragile and will break.
3. Place the lower chamber on top of your cooler with the float
valve fitting inside the cooler's reservoir (see Using Your
ZeroWater Filter Bottle with a Standard Water Cooler on
®
page 6).
4. Install filter cartridges now, using steps 1 through 3 from
instructions on next page.
5. Place the upper chamber on top of the lower chamber. Be
sure that the lower chamber divider ring is tightly affixed
around the lower chamber (see ZeroWater
components on page 4).
6. Place the lid on top of the upper chamber.
USE AND CARE
Filter Bottle
®
Filter Bottle
®
5