GE PHP9030DJBB Instrucciones De Instalación

Installation
Instructions
If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or visit our website at:
GEAppliances.com. In Canada, call 800.561.3344 or visit our website at: geappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
for local inspector's use.
IMPORTANT
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
This appliance must be properly
grounded.
ATTENTION INSTALLER
•
— ALL COOKTOPS MUST BE HARD WIRED
(DIRECT WIRED) INTO AN APPROVED
JUNCTION BOX. A "PLUG AND RECEPTACLE" IS
NOT PERMITTED ON THESE PRODUCTS.
• Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
PARTS INCLUDED
Baffle
(For all installations
except over an oven)
4 Phillips Screws
WB01X1137
Foam Tape
WB06K5042
30 and 36"
Electric Cooktop - Induction
— Save these instructions
— Observe all governing
2 Hex-Head Screws
2 Hold Down
Brackets
or order alternate
installation kit
WB01X24570
MATERIALS YOU WILL NEED
Junction Box
(Sized for conduit per
local electrical codes.)
TOOLS YOU MAY NEED
Pencil
Phillips Head
Screwdriver
1/4" Nut Driver
Ruler or Straightedge
CUTTING THE COUNTERTOP
If you are installing the cooktop in a solid surface
material such as granite, quartz or any other natural
or synthetic solid surface, we recommend that the
cutout be prepared by a professional cabinet or
countertop installer.
Cooktop cutouts in wood or wood-laminate
countertops may be able to be prepared using a
saber saw and electric drill.
Large Size 90º or Straight
Wire Nuts Squeeze Connector
for 1" Conduit
Saber Saw
1/8" Drill Bit & Electric or
Hand Drill
Safety Glasses
31-2000021-1 09-17 GEA