Rola ADJK Guía De Instrucciones página 21

INSTALLATION INSTRUCTIONS
5. Slide the DFE end supports into the rails and up to the positioning slider end tabs at their preset
positions (X and Y).
Fig. A
Tip: place bar upside down for
easier handling of parts
6. Lock the DFE end supports into position by closing the cam levers. Fig. B
!
Note: Insure that the end support has not
moved after closing cam lever.
7. Slide the outer under-­cover strips into the bar, mark with a pencil for length, remove and cut.
Fig. C
Tip: Cut approx. 1/8" or 2mm longer than needed to avoid gaps.
Slide under-­covers into place and install the end caps.
Fig. C
Note: Careful not to pinch
fingers or hand!
End Tab
Fig. B
PAGE 8 59970N Rev B • Questions? (800) 234-­6992 • ROLAProducts.com
Cam Lever