Rola AP-GTX 59832 Instrucciones De Ajuste

Note: Prior to Assembly
Prior to assembling your cross bar kit check that the kit
contains all the parts you will need to fit the cross bars.
Refer to parts lists for guidance. L-Wrench is stored in the
End Support.
Please read these instructions before assembly.
Step 1: Removing the vehicles anchor point covers.
A. On the vehicles roof or ditch molding you will find fore and aft
anchor point covers. (fig 1)
B. Carefully remove these covers by sliding them in the direction
shown on the cover. This will reveal the anchor points. It is
advisable to screw the bolts into the anchor point threads at
this time to clean the threads.
Note: Take care when removing the covers to avoid damaging or
losing clips. Covers will not be replaced while the cross bars are
on the vehicle.
Store the covers and any plugs while cross bars are in use for
later replacement.
Anchor point
cover
Vehicle's roof
Location of anchor points on vehicle
Step 2: Installing Rubber Gaskets and Adaptor
A. Position the rubber gaskets over the anchor points as
shown in figure. (fig 2)
B. Ensure that the gasket is properly aligned.
C. If your gasket has a directional arrow this always points
toward the front of vehicle.
D. Ensure that the gasket slots are centered over the anchor
point threads in the roof.
E. Place the plastic adaptors into the gasket's recessed top
surface. (fig 3) Repeat for all four anchor points. (fig 4)
59832-3N Rev 10/11/11
Fitting Instructions
AP-GTX (Anchor Point GTX)
Cross Bar Kits
Anchor point
Fig 1
L-Wrench – Security
Key(2) (Stored in End
Support)
Bolt (4)
Vehicle's roof
Fig 2
Printed in China
PART No:
59832 / 59833
CARRYING CAPACITY:
Parts list
Cross Bar / End Support
Assembly (2)
Plastic adaptor (4)
Rubber Gasket (4)
Key (4)
Plastic adaptor
Rubber Gasket
Anchor point
Vehicle's
Fig 3
50Kgs/
110 Lbs
roof
Front of vehicle
Fig 4
Pg 1 of 2