Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Transcend 365 miniCPAP Quick Guide
Check that the reservoir is at its full capacity by holding it vertically and
4.
viewing the water level. The water should be level with the max fill line.
5.
Once the reservoir is filled completely, set it on a secure, flat surface and line up
the heater wick with the opening in the reservoir. Hold the reservoir in place and
set the CPAP onto it so that the magnets snap the pieces together securely.
NOTE:
The humidifier reservoir must be emptied before transporting to avoid
damage to the CPAP.
Figure 1 Line the heater cartridge up with the opening in the reservoir. Lower the device
onto the reservoir. Magnets will engage to hold the two parts together.
NOTE:
Be careful while inserting the heater wick into the reservoir so that the
reservoir seal does not get folded over, as this will generate water leaks.
Reservoir should
be filled to the
'Max Fill' line
Line up the heater wick with
the opening in the reservoir
Page 21
Publicidad
Tabla de contenido
