Hardware Installation - Belkin F5U220 Manual Del Usuario

Hardware Installation

(1)
(2)
(3)
(4)
EN
(5)
(6)
(7)
(8)
(9)
(10)
4 4
POWER OFF THE COMPUTER AND DISCONNECT THE POWER
CORD.
Remove the screws that secure the computer cover and remove
the cover.
Touch any part of the metal case to ground yourself. This will
discharge any static electricity that could damage your PCI card or
computer.
Locate an empty PCI expansion slot
Remove the port cover from the back of the PC that corresponds to
the PCI slot you selected. If the port cover is secured with a screw,
remove the screw and place it in a safe spot. You will need to
reuse the screw to install the PCI card.
Insert the PCI Card into the slot. Apply pressure as needed until
the Card is fully seated.
Now secure the PCI Card with the screw that you removed in step
#5.
Replace the computers cover.
Replace your computer power cable and insert the Belkin USB 2.0
driver installation CD into your computers CD-ROM drive.
Turn on power and start the Windows operating system.