Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Read, understand
and follow all warnings
and instructions
contained
in this manual. DO NOT skip
any of the warnings
and instructions
contained
in the preceding
sections of this manual.
LIGHTINGINSTRUCTIONS:
Follow the instructions
exactly.
1.
OPEN THE GRILL LID before attempting
to light a burner so that fumes do not accumulate
inside
the grill. An explosion
could occur if grill lid is down.
2.
Check that all burner control
knobs and the cylinder valve are turned to the "OFF" position.
3.
Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise
to full open.
4.
DO NOT stand with head, body, or arms over the grill when lighting.
LIGHTINGTHE MAIN BURNERS:
1.
Open lid before lighting burner.
2.
Make sure all control knobs are in the "OFF" position.
3.
Select the burner to be lit. Push and turn the control knob of that
burner to the "HIGH" position.
4.
Press the electronic
igniter and hold for 3-5
seconds to light burner.
5.
If ignition does NOT occur in 5 seconds, turn control knob to "OFF",
wait 5 minutes
to allow gas to dissipate
and repeat lighting procedure.
6.
Repeat steps 3-5
for lighting each burner. Always use electronic
igniter for lighting each burner. If burner does not ignite using the
push-button
igniter, wait 5 minutes,
see "Match Lighting the Main Burners" section.
7.
To turn off, turn each control knob clockwise
until it locks in the "OFF" position.
This does not turn off
the gas flow from the cylinder.
Note:
If burner does not light or flame is too low, you may have spider or other insect blockage
in
burner, or the flow limiting device has been activated.
See "Burner Assembly/Maintenance"
under Proper Care and Maintenance,
or "Regulator
Resetting
Procedure"
under Connecting
LP
Cylinder and Hose/Regulator
to Grill.
MATCH LIGHTINGTHE MAIN BURNERS:
1.
Open lid before lighting.
Lighting Hole
2.
Turn the burner control knobs to "OFF".
3.
Place a paper match in the end of the matchlighter.
Strike the match
and place through
lighting hole in the left hand side of the grill to
approximately
1/2" (1 to 2 cm) from the burner.
4.
Turn on the FAR LEFT burner control knob to the "HIGH" position.
The burner should light within 5 seconds.
5.
If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate
and repeat lighting procedure.
6.
Once lit, light adjacent
burners in sequence
by pressing
in and
rotating the control knob to the "HIGH" position.
7.
If the burner does not light within the first few attempts
of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder.
DO NOT attempt to operate the grill until the
problem
is found and corrected.
See "Trouble Shooting" section of this manual.
10
Publicidad
Tabla de contenido
