Preparation Of Premises And Machine Installation - Enofrigo DOGE Serie Manual De Instrucciones

Idiomas disponibles

Step 2

rest the machine gently on the ground

Step 3

remove the packaging and gently raise the machine with the forklift truck,

being careful not to damage it , until the pallet can be removed

Step 4

rest the machine gently on a flat uniform surfaces as near as possible to its final position

11. PREPARATION OF PREMISES AND MACHINE INSTALLATION

The room in which the machine will be installed, like the various existing systems, must comply with current

local regulations and technical specifications.

Position the machine in a dry well-ventilated place in compliance with the local technicalhealth regulations. In

particular:

• Avoid positioning the machine near sources of heat (radiators, ovens, burners etc.) or draughts. If this is not

possible, the following minimum distances must be observed: 50 cm from coal or oil cookers and 50 cm from

electric/gas and 30 cm from walls.

• Avoid the risk of power failures by ensuring that the machine is not exposed to direct sunlight.

• Make sure that the machine ventilation apertures are not covered.

Carefully unpack the machine, removing the main cardboard box and then all the packaging

protection materials.

Once you have removed the packaging, check that the machine is in perfect condition and notify the

manufacturer or authorised dealer of any damage found within 48 hours from receipt of the goods.

For installation of the machine, take account of the data given on the identification plate and the overall

dimensions (see chapter n° 5 and n° 6).

A free space of approximately 50 cm must be left around the machine for operation and maintenance.

N.B. = Connect the electric supply cable to a suitable plug (this operation must be done by a qualified

technician)

You are strictly forbidden ti use the machine in places where there is the danger of explosion or fire due

to the presence or development of dust, gas or explosive or flammable mixtures.

The packaging materials must be disposed of in compliance with current local regulations concerning

industrial and special waste.

CT68900001_

Rev.00 07/13

Tabla de Contenido